Brother MFC-J5340DW Quick Setup Manual

Quick Setup Guide
MFC-J5340DW / MFC-J5855DW / MFC-J5955DW
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct installation procedure.
EN FR
1
Unpack the machine and check the components
Remove the protective tape or film covering the machine and the supplies. The components included in the box may differ depending on your country.
• Most of the machine illustrations in this Quick Setup Guide show the MFC-J5955DW.
• The images in this guide are for illustration purposes only and may differ from the
actual products.
2
Load plain Letter/A4 paper
Pull the paper tray completely
out of the machine as shown
by the arrow. Remove the tray
top cover.
Connect the
3
power cord
NOTE Open the ink cartridge cover.
You can adjust the control
For MFC-J5340DW only:
panel angle to read the LCD
Remove the orange protective part
more easily.
from the machine. Follow the
LCD instructions to store the orange
protective part inside the machine.
If you must transport the machine,
remove the ink cartridges and
replace this part.
6
Check the print quality
Follow the LCD instructions, Follow the LCD instructions and
and then press [Start]. check the quality of the four color
The machine prints the Print blocks on the sheet, and then
Quality Check Sheet. start the cleaning procedure if
required.
Video setup instructions:
support.brother.com/videos
Fan the paper well. Load the paper in the tray
and adjust the paper guides.
4
Install the starter ink cartridges
OK Poor
The latest manuals are available at the Brother support website:
support.brother.com/manuals
Manuals in Spanish for this model are available at support.brother.com.
Manuales en Español para este modelo están disponibles en support.brother.com.
NOTE
• Save all packing materials and the box in case you must ship your machine.
• You must purchase the correct interface cable for the interface you want to use.
USB cable
Use a USB 2.0 cable (Type A/B) that is no more than 16 feet (5 meters) long.
Ethernet (Network) cable
Use a straight-through Category 5 (or greater) twisted-pair cable for 10BASE-T or 100BASE-TX
Fast Ethernet Network.
After finishing the machine setup, you can change the paper type or size. For more information
about paper handling, see the Online User's Guide at support.brother.com/manuals.
Do not exceed
this mark (bbb).
Quickly shake just the
black ink cartridge
horizontally 15 times as
shown, before inserting
it into the machine.
Adjust the print alignment (recommended)
7
To adjust the print alignment before using your machine, press [Start].
Follow the LCD instructions
to print the Adjustment
Sheet. The black circle mark
is located in the upper right
corner of the sheet.
Put on the tray top cover, Pull out the paper support until
and then slowly push the it locks into place.
paper tray completely into
the machine.
5
Follow the LCD instructions Follow the LCD instructions to
to install the ink cartridges. set the date and time.
Close the ink cartridge
cover. The machine will After setting the date and time,
prepare the ink tube you can set the Brother LCD
system for printing. Message defaults.
NOTE
The first time you install the
ink cartridges, the machine
will use extra ink to fill the
ink delivery tubes. This is a
one-time process that enables
high-quality printing.
Place the Adjustment Sheet
face down on the scanner
glass. Make sure the black
circle is in the upper left corner
of the scanner glass.
D01Y3M001-00
USA/CAN
Version 0
Set the date
and time
Follow the LCD instructions
and complete adjusting the
alignment.
When finished, remove the
Adjustment Sheet from the
scanner glass.