Table of Contents
Advertisement
6 Operating the Application
6.7
Scenario 6: Observe the course of the controlling by
means of LOGO!SoftComfort
LOGO!Soft Comfort V7.1 offers the possibility of displaying the course of the
controlling of the PI controller in a curve and to observe it live
Table 6-7
No.
1.
Open the LOGO!Soft Comfort project
(file 23753479_Set23_RegSim_V23.lsc, see Table 4-2)
with LOGO!Soft Comfort V7.
Click on the function "Online Test".
2.
3.
Click on the symbol with the glasses at the lower rim of the
screen.
4.
Drag the mouse cursor to the PI controller and then click on
the symbol with the glasses.
The trend view of the LOGO!Soft Comfort opens up.
Click on the "trendline" "SP" to display the trend "SP".
5.
The red trend named "AQ" displays the setpoint speed
(n
) [‰].
set
The green trend named "SP" displays the setpoint pressure
(P
) [mbar].
set
The blue trend named "PV" displays the actual pressure
(P
) [mbar].
act
If the following message pops up, you must transfer the LOGO! project again to
Note
be able to perform the online test.
Therefore, you should avoid changing the parameters directly in the LOGO! logic
module.
Set23_RegSim
Entry ID: 23753479,
V2.3.S,
Action
02/2014
Comments
30
Advertisement
Table of Contents
