Assembly Of Applicator - Pioneer APPLI-PRO DASIC Manual

ASSEMBLY OF APPLICATOR

Step 1
Thread the intake assembly into side tank fitting, and make sure filter is pointed towards the front of
the tank as well.
Step 2
Locate free end of hose that is installed to the pump's intake. Attach it to the elbow (003-EL1438)
next to filter on side of tank. Tighten hose clamps.
Step 3
The gauge will need to be mounted in a location that is easily viewable from the operator's station.
Below are two options that the operator can use to mount the gauge that best suits their application
system.
Option A – Pump mounted gauge
Attach gauge (002-2207P) to fitting (003-TT12) on discharge assembly and tighten. Gauge should be
facing directly away from tank.
Intake
assembly
on side of
tank
4
Attach free
hose end to
elbow
Thread in
gauge here