Table of Contents
Advertisement
ASSEMBLY OF NOZZLE BAR
The Appli-Pro Basic system comes with the ability to use one, two, or three nozzles at a time. Set up
your nozzle bar as follows-
1. Loosen the screw on ½" Bar Clamp (004-1209). Do not fully remove screw.
2. Slide top half of bar clamp off.
3. Hold bottom half of bar clamp to bottom side and center of nozzle bar (001-4707C).
4. Slide two-way nozzle body into square slot of bar clamp.
5. Slide square slot of top bar clamp into nozzle body and screw, then tighten screw.
6. Repeat for remaining nozzle bodies one on each side of center. Leave screw loose unit
aligned.
7. Measure the width of the area that you want to spray. Divide it by five. Place the two outside
nozzles in from the outside edge by using this measurement.
Example: The width of your round baler pickup head is 60 inches. Divide this by 5 and you will get 12
inches. Place the two outside nozzles 12 inches from the outside edge of the pickup head. Cut hose
to length between nozzle bodies and secure them to nozzle bodies with hose clamps.
Note: Hose can be left a little long for additional adjustment at a later date.
Step 1-2
Step 5-6
7
Step 3-4
Advertisement
Table of Contents
