en Troubleshooting
Fault
Loud noises during
the spin cycle.
Banging noises, rat-
tling in the drain
pump.
Slurping, rhythmical
suction noise.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
Detergent residue on
the dry laundry.
44
Cause and troubleshooting
→ "Removing the transit bolts", Page 14.
▶
Foreign bodies have got into the drain pump.
→ "Cleaning the drain pump", Page 35
▶
The drain pump is active, the detergent solution is
pumped out.
Not a fault – normal operating noise.
▶
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Start the 单脱水 programme.
▶
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the 单脱水 programme.
▶
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the 单脱水 programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the 单漂洗 programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Brush out the laundry after washing and drying.
▶