Grounding The Firewall; Installing Interface Modules - HP A-F1000-E Installation Manual

Grounding the firewall

WARNING!
Correctly connecting the firewall grounding cable is crucial to lightning protection and EMI protection.
Follow these steps to connect the grounding cable:
Remove the grounding screw from the rear panel of the firewall chassis.
Step1
Attach the grounding screw to the OT terminal of the grounding cable.
Step2
Use a screwdriver to fasten the grounding screw into the grounding screw hole.
Step3
Ground the other end of the grounding cable, as shown in
Step4
grounding cable to the grounding terminal of the rack.
Figure 10 Connect the grounding cable
(1) OT terminal

Installing interface modules

Follow these steps to install an interface module:
Select the slot to install the interface module, and remove the two filler panels on the slot: use a Phillips
Step1
screwdriver to remove the fastening screws on the filler panel and use a flat-blade screwdriver to prize the
filler panel to remove it from the firewall.
Push the interface module slowly along the slide rails into the slot, and then pull the levers inward.
Step2
1
Figure 10, by connecting the other end of the
13