Related Manuals for LG LCB-003
Summary of Contents for LG LCB-003
- Page 1 Bluetooth Module LCB-003 Bluetooth Module Manual Warranty period: 2 years A/S: 1544-7777...
- Page 2 1. INTRODUCTION 1.1 Overview LCB-003 is a small size and low power module for Bluetooth with PCB antenna. LCB-003 use the nRF52810 solution(Nordic), and it can be applied to air solution etc. Nordic nRF52810 is a highly integrated single-chip low power Bluetooth network controller. It combines an ARM-Cortex M4 MCU, Bluetooth, and RF in a single chip.
-
Page 3: Electrical Specification
3. ELECTRICAL SPECIFICATION 3.1 Absolute Maximum Ratings Description Min. Max. Unit ℃ Storage Temperature Storage Humidity (40℃) 3.2 Operating conditions Description Min. Max. Unit Supply Voltage(BLE) Supply Voltage(Speaker) ℃ Ambient Temperature Ambient Humidity (40℃) 3.3 Power Supply Voltages Input power Unit 3.0V ~ 3.4V VDD_3.3V... - Page 4 3.5 Standard Rated Specification Division Characteristic Host Interface UART Frequency Range 2.402GHz ~ 2.480GHz (2.4GHZ ISM) Dimension L x W x H : 35 x 15 x 4.3 (typical) mm Spread Spectrum GFSK (Gaussian Frequency Shift Keying) Data Rate 1 Mbps 3.6 Electrical Specifications for Bluetooth (Radiation TEST) TX characteristics Parameter...
-
Page 5: Fcc Certification
5. FCC CERTIFICATION 5.1 FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. -
Page 6: Bluetooth Module Specifications
Canada, précédé du mot « contient », ou d’une formulation similaire allant dans le même sens et qui va comme suit : Contient IC : 2703N-LCB003 est le numéro d’homologation du mo Bluetooth module specifications LCB-003 Model Frequency Range 2402 MHz - 2480 MHz EIRP (Max) 7.07 dBm... - Page 7 7. PIN MAP...
-
Page 8: Pin Description
8. PIN Description... - Page 9 9. Module Integration Guide 1. Applicable FCC Rules a. CFR 47 Part 15.247 2. Operational Condition The module is limited to OEM installation ONLY. The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or install module. A separate approval is required for all other operating configurations, including portable configurations with respect to Part 2.1093, Part 15 Subpart B, and difference antenna configurations.
- Page 10 9. Module Integration Guide 9. Additional testing, Part 15 Subpart B disclaimer The grantee should include a statement that the modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification.