Advertisement
9. Module Integration Guide
1. Applicable FCC Rules
a. CFR 47 Part 15.247
2. Operational Condition
The module is limited to OEM installation ONLY. The OEM integrator is responsible for
ensuring that the end-user has no manual instruction to remove or install module. A
separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093, Part 15 Subpart B, and difference antenna
configurations.
3. Limited Module Procedure: N/A
4. Trace antenna designs: N/A
5. RF Exposure consideration
This modular complies FCC/ISED RF exposure requirement at 15 mm distance. Any host
equipment that has separation distance less than 15 mm shall require additional RF
exposure assessment.
6. Antennas
This modular has PCB pattern antenna.
Any changes of antenna designs might require additional assessment.
Antenna type shall be same type and antenna gain shall be less or equal to certified
antenna.
7. Label and compliance information
The end user manual shall include all required regulatory information/warning as shown
in this manual. If the FCC identification number is not visible when the module is
installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module.
This exterior label can use wording such as the following:
"Contains FCC ID : BEJ-LCB003" any similar wording that expresses the same meaning
may be used.
8. Information on test modes and additional testing requirements
This modular was tested in standalone configuration. Integration of this modular into a
host equipment would require additional testing.
Advertisement
