Residual Risks; Re-Commissioning After A Standstill - Bosch rexroth BS 1 Series Assembly Instructions Manual

8.2 Residual risks

Table 8: Residual risks
Location
1 Conveyor medium pinch
point
2 Cross connector,
drive shaft, gear:
between component and
workpiece pallet
3 Conveyor medium:
between running
conveyor and stationary
workpiece pallet
(e.g. during separation)
4 Between workpiece
pallets
5 End of belt section
8.3 Re-commissioning after a standstill
Follow the steps outlined for the initial commissioning.
Situation Hazard
Pieces of clothing or
long hair can be pulled in
Trapping of body parts
Trapping of body parts
Body parts can be
crushed
Crushing injury to body
parts caused by falling
objects
Action
Crushing, pulling Do not reach into the system while it is
out of hair running. Wear protective clothing.
Shearing Do not reach into the system while it is
running.
In the work area OR at transport speeds
v > 15 m/min, a constructive solution,
e.g. a safety fence, is required.
Crushing Do not reach into the system while it is
running.
Crushing Do not reach into the system while it is
running.
In the work area or at transport speeds
v > 15 m/min, a constructive solution,
e.g. separation of the workpiece pallets,
is required.
Crushing A constructive solution is required,
e.g. by means of a stopper.
3 842 563 815/2021-11, MIT: BS 1/..., Bosch Rexroth AG
Commissioning 23/40