NEC Express 5800/320Lc User Manual page 166

4-34 System Configuration
SCSI Bus Settings
If you put the cursor on "SCSI Bus Settings" with keyboard cursors (↓ and ↑) in the "Configuration
Settings" menu and press Enter, the screen for setting the information on the SCSI bus of the host
adapter appears.
The table below shows the parameters of the setting items and their factory settings.
IMPORTANT:
The settings can be made for each SCSI bus.
Submenu item
SCSI Bus SCSI ID
SCSI Bus Reset
SCSI Bus Reset
Delay
SCSI Bus
Termination
Autoconfigure SCSI Device
If you put the cursor on "Autoconfigure SCSI Device" with keyboard cursors (↓ and ↑) in the
"Configuration Settings" menu and press Enter, the screen for setting the information on the device
connected to the host adapter appears.
The parameters of the setting items and their factory settings are the same as those shown in the
table for "SCSI Device Settings."
IMPORTANT:
The settings can be made for each SCSI bus and SCSI ID. Check the SCSI ID of the target
device before changing the settings.
The factory settings are the same for both SCSI bus 0 and SCSI bus 1.
The following items can be changed by setting "Adapter Configuration" in "Host Adapter
Settings" to "Manual."
– Enable Device
– Enable LUNs
– Negotiate Wide
– Negotiate Sync
– Tagged Queuing
– Sync Offset
– Sync Period
– Exec Throttle
Parameter
SCSI Bus0 SCSI Bus1
0, 1, 2, 3, 4, 5, 6, 0, 1, 2, 3, 4, 5, 6,
[7], 8, 9, 10, 11, [7], 8, 9, 10, 11,
12, 13, 14, 15 12, 13, 14, 15
[Enabled] [Enabled]
Disabled Disabled
0, 1, 2, 3, 4, [5], 0, 1, 2, 3, 4, [5],
6, 7, 8, 9, 10, 11, 6, 7, 8, 9, 10, 11,
12, 13, 14, 15 12, 13, 14, 15
Auto [Auto]
High only High only
Disabled Disabled
[Enabled] Enabled
Description
Select the SCSI ID given to SCSI
bus.
Make the reset valid or invalid in
SCSI buses.
Leave this item as factory-set.
Set the termination resistance of
SCSI bus.
[ ]: Factory-set