Table of Contents
Advertisement
5. INSTALLATION
This section provides information for installing an 86431 Power Unit.
JungleMUX nodes are shipped with Power Units installed as per the Node
Assignment Drawing for the node.
configurable parameters and therefore no software programming is required.
The 86431 Power Unit has ESDS components and therefore standard static
protection precautions should be observed when handling, packing or
Pre-installation
Visually check the unit for damage. Ensure that the jumper P2 (applicable to
B86431-4X units) is in Normal position and the screws are in place and firmly
tightened. Keep the shipping containers and packing materials for future use. If
a unit is damaged, file a claim with the shipping agent or the local GE Multilin
representative.
Shelf Position
The Power Units are normally installed in both the 1st and 15th shelf slots of
each JungleMUX shelf. Power Units are paralleled so in the event of single unit
failure the shelf power is maintained. If necessary, an additional (third) Power
Unit can be installed in the shelf. The power buses of multiple shelves belonging
to the same JungleMUX node can be paralleled (refer to the 86430 Equipment
Shelf TPIM).
It is recommended that no more than six Power Units be
paralleled.
A typical rack layout is shown in Figure 5.
Copyright GE Multilin Inc. 2001-2013
The Power Unit does not have any
CAUTION
shipping the unit.
342-86400-431PS
Issue 2.1
March 2013
Page 14
All
Advertisement
Table of Contents
