5. INSTALLATION
The following section provides a step-by-step procedure for installing a 86447 LS
DATA unit. The LS DATA unit's nonvolatile memory is shipped from the factory
as per the node assignment drawing for the purchased system. All spare units
or loose units are shipped with factory default settings in memory.
The 86447 LS DATA unit has ESDS components and therefore standard
static protection precautions should be observed when handling, packing
Preinstallation
Visually check the unit for damage. Ensure that all jumpers, if applicable, and
screws are firmly tightened or in place.
packing materials for future use. If a unit is damaged, file a claim with the
shipping agent or representative and call the Product Support Center referred to
at the start of the manual.
Shelf Position
The LS DATA unit and associated Paddle Board can be inserted in channel slots
2 to 14 of a 86430-02 shelf or in slots 2 to 9 of a 86430-01 common equipment
shelf. The remaining slots are reserved for common equipment units. Figure 3
shows a typical rack layout for a ring configured system dropping a maximum of
seven VTs.
The LS DATA unit can be inserted and removed from the shelf with shelf power
applied.
Power Requirements
Power for the 86447 LS DATA unit is supplied from the shelf, therefore no
external power supply is required.
Copyright GE Power Management 2001
CAUTION
or shipping the unit.
Keep the shipping containers and
342-86400-447PS
Issue 1
March 1994
Page 13