Panasonic DMP-BD90 Owner's Manual page 23

You have forgotten your ratings password.
You want to cancel the ratings level.
The ratings level returns to the factory
defaults.
1 While the unit is on
Press and hold
[
[0] on the remote control at the same time for
more than 5 seconds.
– POWER LED starts to flash, and "00 RET"
is displayed on the screen.
2 Press [1] (right) repeatedly on the remote
control until "03 VL" is displayed on the screen.
3 Press [OK].
The TV screen turns black.
In the following cases, HDMI authentication
takes place and a black screen is displayed:
– When "24p Output" is set to "On".
This unit does not recognize the USB
connection correctly.
Disconnect and re-connect the USB cable. If
it still does not recognize the connection, turn
this unit off and on again.
USB devices may not be recognized by this
unit when connected using the following :
– a USB hub
– a USB extension cable
If you connect USB HDD to this unit, use the
USB cable that is supplied with the HDD.
If the USB HDD is not recognized, the power
to the USB HDD may not be supplied. Supply
power from an external source.
on the main unit and the
]
Settings
Picture
The images from this unit do not appear on
the TV.
Picture is distorted.
An incorrect resolution is selected in "HDMI
Resolution". Reset the setting as follows:
1 Turn the unit on.
2 Press and hold
[8] on the remote control at the same time for
more than 5 seconds.
3 Set the item again. (
– When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD
select "Yes" in "Restore Default Settings"
( 21) and make proper settings.
Video is not output in high-definition.
Confirm that "HDMI Resolution" in the Setup
menu is set properly. (
- 23 -
on the main unit and the
[ ]
18)
audio are not output properly,
®
18)