Table of Contents
Advertisement
16
CLEANING AND CARE
The Electrolux integrated burner has been constructed
from select grade stainless steel which, if not cared for,
may discolour over time. To keep your appliance looking
its best we recommend that the cooking surfaces are
cleaned after every use.
Cleaning
•
Always ensure the appliance is turned off before
cleaning.
•
This appliance contains brass and aluminium fittings.
Do not use caustic based cleaners
•
Do not use steam cleaners as this may cause moisture
build up on electrical components.
•
Always clean the appliance immediately after any
food spoilage.
CAUTION!
Do not place cast iron trivet or grill plate in
a dishwasher.
WARNING!
Please ensure that your appliance is switched
off and has cooled down before following the
instructions below.
Cleaning of Stainless Steel surfaces
CAUTION!
Do not use abrasive or caustic cleaners, scourers or
metal scrapers on the stainless steel surfaces as they
may permanently scratch and damage your appliance.
•
Wash all stainless steel components, including the
slimline lid and control knob cap with a soft dishcloth
using hot soapy water.
•
The interior can be wiped down with a soft cloth in hot
soapy water.
•
Ensure that all surfaces are dried with a clean
dry cloth.
CAUTION!
Take extra care (particularly when cleaning on and
around the control knob) to ensure that water and
soapy residue do not enter the control panel, where
the valve is located or into the burner.
Trivet and reversible grill plate
The trivet can be removed for cleaning. Clean by washing
in warm soapy water. Take care when replacing the trivets
as dropping them may damage the enamelled surfaces.
Burner
The burner ports should be checked for blockages and
cleared as required. The brass top of burner will become
discoloured with use, this is normal.
MAINTENANCE
IMPORTANT!
Special note on "tea staining"
Sometimes stainless steel surfaces are affected by a
brown discolouration called tea staining. This usually
occurs in areas which use high heat and can be easily
removed using specialised stainless steel cleaners. For
best results, we recommend that specialised cleaners be
used regularly on all stainless steel components. You will
find these cleaners at Electrolux spare parts outlets.
Burners
Burners should be checked at least once per year and
cleaned as necessary. Inspect burners to ensure no
residues have been deposited and gas ports are clear.
NOTE: Environmental conditions need to be taken into
account with regards to the maintenance required on
your product. In particular units installed in humid climates
or seaside locations will be more susceptible to surface
corrosion/discolouration over time. In these conditions
Electrolux strongly recommends cleaning and drying your
barbecue after every use and covering it when not in use
to minimise exposure to the elements.
Advertisement
Table of Contents
