Electrolux EQBW316AS User Manual page 9

2. Remove two screws fastening burner.
3. Remove burner from burner box.
Burner
4. Replace Universal LPG Injector (1.25mm) with
Natural Gas injector (2.10mm).
5. Replace burner and cover panel.
6. Remove LPG sticker on the base panel and replace
with natural gas sticker provided.
Screw
The final step in the conversion of the barbecue to Natural
Gas is the adjustment of the turndown setting. This can
only be completed after the barbecue has been connected
to a supply of natural gas. Refer to 'Connection to Natural
Gas Supply' detailed in next section.
Adjust the turndown setting on the valve.
To complete the conversion to natural gas the turndown
setting of the valve will need to be adjusted, and at the
same time the operation of the appliance can be tested.
Proceed as follows:
• Check that the burner ignites (REFER OPERATING
INSTRUCTIONS).
• Light the burner and rotate the control knob to the
lowest setting, then remove the knob from the valve
shaft, and remove the grommet.
• Using a small flat-blade screwdriver adjust the
turndown adjustment screw to achieve a small steady
flame on the burner.
• Replace the grommet and the knob.
• Recheck the operation of the burner at maximum
and turndown.
Injector
Turndown adjustment screw
9