Configuring Client Pc; Tcp/Ip Configuration; Windows 98/Me - Philips CPWBS154 Instructions For Use Manual

Configuring Client PC

After completing hardware setup by connecting all your network devices,
you need to configure your computer to connect to the ADSL Wireless
Base Station.
See: 'Windows 98/Me' on page 11-13
'Windows NT 4.0' on page 15-17
'Windows 2000' on page 19
'Windows XP' on page 21
or 'Configuring Your Macintosh Computer' on page 22-23
depending on your operating system.

TCP/IP Configuration

To access the Internet through the ADSL Wireless Base Station, you must
configure the network settings of the computers on your LAN to use the
same IP subnet as the ADSL Wireless Base Station.The default IP settings
for the ADSL Wireless Base Station are:
IP Address
Subnet Mask
DHCP function
DHCP IP Pool Range
Note: These settings can be changed to fit your network requirements, but you
must first configure at least one computer to access the ADSL Wireless
Base Station's web configuration interface in order to make the required
changes. (See 'Configuring the ADSL Wireless Base Station' on page 25
for instruction on configuring the ADSL Wireless Base Station.)

Windows 98/Me

You may find that the instructions in this section do not exactly match your
version of Windows.This is because these steps and screen shots were
created from Windows 98. Windows Millennium Edition is similar, but not
identical, to Windows 98.
1 On the Windows desktop, click Start/Settings/Control Panel.
ENGLISH
192.168.1.1
255.255.255.0
Enable
192.168.1.2 to 192.168.1.254
11