Preparations; Rear Connections - Philips MCM148 User Manual

Rear connections

The type plate is located at the rear of the system.
A Power
– Before connecting the AC power cord to the
wall outlet, ensure that all other connections
have been made.
– If your system is equipped with a Voltage
Selector, set the VOLTAGE SELECTOR to the
local power line voltage.
WARNING!
– For optimal performance, use only the original
power cable.
– Never make or change any connections with the
power switched on.
To avoid overheating of the system, a safety circuit
has been built in. Therefore, your system may switch
to Standby mode automatically under extreme
conditions. If this happens, let the system cool down
before reusing it (not available for all versions).
B Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
terminals, right speaker to "RIGHT" and left
speaker to "LEFT", coloured (marked) wire to
" + " and black (unmarked) wire to " - ".
1
●
Fully insert the stripped portion of the speaker
wire into the terminal as shown.
Notes:
– For optimal sound performance, use the supplied
speakers.
– Do not connect more than one speaker to any
one pair of + / - speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.

Preparations

2
9