Boring The Hanger Holes; Hammering The Wall Plugs; Installing The Hanger Screws - Beko HCA63640B User Manual

5 Installation of appliance
(Figure 1a)
External flue connection plate
(Figure 1b)
If you will use Ø 120 mm flue pipe, install Ø 120
mm flue adapter onto it.

5.4 Boring the hanger holes

Affix the installation template onto the installation
place of the hood. Drill the points market with (X,Y)
using a Ø8 mm bit and points market with (Z) us-
ing a Ø6 mm bit. (Figure 2)
8
8 mm plastic
8
wall plug
14 / EN
Hanger plate
Z
Z
Y
Y
X
8
X
6 mm plastic
wall plug
Z
Y
X
Bottom surface of the appliance
COOKING ZONE
(Figure 2)

5.5 Hammering the wall plugs

Hammer Ø8 mm wall plugs (X,Y) into the holes
drilled for hanger screws. Hammer 2 x Ø6 mm wall
plugs (Z) into the holes drilled with a Ø6 mm bit for
the external flue connection plate. (Figure 3)

5.6 Installing the hanger screws

Install 4.9x50 hanger screws into the Ø 8 mm wall
plugs (Y) you have hammered into the wall. There
must be a gap of 5 mm between the screw head
and the wall. Connect the internal flue connection
plate to the 8 mm wall plugs (Z) on the wall using
Ø3.9x22 screws. (Figure 3)
Cooker Hood / User Manual