System Admin; Admin - D-Link M32 Manual

Section 3 - Configuration
This page will allow you to change the administrator (Admin) password and
enable the HTTPS server. In the Management menu on the bar on the top of the
page, click System Admin.
Admin Password
Password: Enter a new password for the administrator account. You will need to enter
this password whenever you configure Mesh Point A using a web browser.
Enable Graphical Enables a challenge-response test to require users to type letters or numbers
Authentication
from a distorted image displayed on the screen to help prevent online hackers
(CAPTCHA): and unauthorized users from access to your network.
Advanced Settings - Administration
Enable HTTPS
Check to enable HTTPS to connect to the extender securely. Instead of using
Server: http://WXYZ.devicesetup.net/, you must use http://WXYZ.devicesetup.
net/ in order to connect to Mesh Point A. WXYZ: 4 digits suffix of MAC Address
Note: If you previously changed the management link in the Network section,
replace chttp://WXYZ.devicesetup.net/ with the new management link.
Enable Remote
Remote management allows Mesh Point A to be configured from the Internet
Management: by a web browser. A password is still required to access the web management
interface.
Enable Admin
The port number used in the URL to access Mesh Point A.
Port: Example: http://x.x.x.x:8080 where x.x.x.x is the Internet IP address of Mesh
Point A and 8080 is the port used for the web management interface.
Note: If you enabled Use HTTPS and wish to access Mesh Point A remotely
and securely, you must enter https:// at the beginning of the address.
D-Link M32 User Manual

System Admin

Admin

61