Page 1
LCD PROJECTOR LENS MODEL NO. LNS-W04/LNS-W05/LNS-W06/LNS-W07 LENS INSTALLATION AND REPLACEMENT PROCEDURES NOTES ON REPLACEMENT AND INSTALLATION The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet of your projector and install the lens following this procedure precisely.
Page 2
NOTES ON LENS INSTALLATION • Lens installation and replacement should be made by the qualified service per- sonnel. • Be sure to install the lens following this procedure precisely. • Do not touch or remove any parts except the lens and related parts. It may result in malfunctions, electrical shock, fire hazard or other accidents.
Page 3
LENS REPLACEMENT AND INSTALLATION PROCEDURE Disconnect the power cord from AC outlet. Remove 5 screws (A) from the front cabinet. Pulling up the front cover and remove it. (See Fig-1.) Pulling up Light Block Sheet Holder and Cover Plate, remove them. (See Fig-2) Remove the cover plate from the light block sheet holder .
Page 4
Remove lens cap on the rear (mounting side) of the projection lens and mount Lens Attachment to the lens with four screws included with the lens. Insert the connector at the end of Lens Motor Lead into the socket located at right-top of the lens attachment.
Page 5
Release Lens Lock (Clockwise) Pinch the tab and turn lever clockwise to unlock the lens. Fix Lens Lock (Anticlockwise) Pinch the tab and turn the lever anti- clockwise to lock the lens. CAUTION: Turn the Lens Lock Lever anticlockwise until the lens is locked. Make sure the lens is securely installed after installation.
Page 6
Note: Make sure the light block sheet is fully inserted into the light block sheet holder when installing the light block sheet and the sheet holder into the projector. Improper installation may cause the lens malfunction. Light Block Sheet LNS-W04/LNS-W05/LNS-W06 TYPE F14A (610 315 7337) Back of Light Block Sheet Replace the front cover and secure it with the 5 screws.