Please check the following before calling for service. It may save you time and expense.
prOBleM
Part or all of Warming
1
Drawer does not operate.
Food in Warming Drawer is
2
not heated.
Warming Drawer light does
3
not work.
Touch controls will not
4
operate.
Power light off.
5
Drawer does not slide
6
smoothly or drags.
Excessive condensation.
7
No heat in the proof setting.
8
Food dries out.
9
pOssiBle Cause
•
Power cord of Warming Drawer is not
completely connected to the electrical
outlet.
•
Power outage.
•
Fuse blown/circuit breaker tripped.
•
No power to the appliance.
•
Drawer controls improperly set.
•
Light bulb is loose or burned out.
•
Power cord of Warming Drawer is not
completely connected to the electrical
outlet.
•
Power outage.
•
Fuse blown/circuit breaker tripped.
•
Power failure.
•
Ball bearings are out of alignment.
•
Drawer over-loaded or load unbalanced.
•
Drawer not replaced properly after removal.
•
Liquid in Warming Drawer.
•
Uncovered foods.
•
Temperature setting too high.
•
Incorrect Humidity setting.
•
Room temperature may prevent the thermostat
from tripping on.
•
Moisture escaping.
BeFOre yOu Call FOr serviCe
•
Make sure the power cord is tightly connected
to the outlet.
•
Check house lights to be sure. Call your local
electric company for service.
•
Replace the fuse or reset the circuit breaker.
•
See SOLUTION for PROBLEM 1.
•
Check if the controls have been properly
set.
•
Call for service.
•
Make sure the power cord is tightly connected
to the outlet.
•
Check house lights to be sure. Call your local
electric company for service.
•
Replace the fuse or reset the circuit breaker.
•
If the Warming Drawer was in use, you must
reset the heating function.
•
Fully extend the drawer and push it all the way
in. See the Care and Cleaning section.
•
Reduce weight to less than 50 pounds.
Redistribute drawer contents.
•
Remove drawer and replace again.
•
Remove liquid.
•
Cover food with lid or aluminum foil.
NOT use aluminum foil to line any part of
the Warming Drawer.
•
Reduce temperature setting.
•
Set the Variable Humidity Control to the open
vent setting to allow venting.
•
Press TEMP to select LOW and then select
PROOF.
•
Cover food with lid or aluminum foil.
NOT use aluminum foil to line any part of
the Warming Drawer.
•
Set the Variable Humidity Control to the
closed vent settings to prevent venting.
11
sOlutiOn
DO
DO