Mitsubishi Electric KD Series User Manual page 60

4-3-1 Communication control block diagram
【Line sync signal 】
1. External sync. mode
External sync signal, input through communication port, is distributed
to the other block inside CIS. The line data from each block is
synchronized at line scan basis.
2. Internal sync mode
Sync signal created inside CIS is distributed to the other block inside
CIS. The line data from each block is synchronized at line scan basis.
【Remarks】
1) CIS can be controlled only through Master port. (Signal through the
other ports will not be reflected to CIS)
2) Confirm where to be connected from your Grabber board.
TM－XJ101C
4-3 Communication control (overview)
... ...
CoaXpress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
【Communication control 】
L4 and L5 types have two signal blocks for CoaXpress® ,
For L6 only
and the 1
block. Main functions of the CIS can be controlled through the
D1 of Master block.
In case of using of the external sync mode, input trigger
signal to the 1
internal sync. mode.)
Slave block (Connector D5 to D8) is mainly used only to
change settings related to link control of CoaXpress® . When
you change a part of register values in Master block, you need
to change the part of register values in Slave block. (Register
information used for the Slave system is stored on the CIS as
XML file for the Slave. Please refer Appendix.A to show detail
of resister which should be changed.)
L6 type have three signal blocks for CoaXpress® , and the
2 signal block (Connector D5 to D9) is the Master block. Main
nd
functions of the CIS can be controlled through the D5 of Master
block.
In case of using of the external sync mode, input trigger
signal to the 2nd Master port (D5). (No input required for the
internal sync. mode.)
Slave block (Connector D1 to D4 and D9-D12) is mainly
used only to change settings related to link control of
CoaXpress® . When you change a part of register values in
Master block, you need to change the part of register values in
Slave block. (Register information used for the Slave system is
stored on the CIS as XML file for the Slave. Please refer
Appendix.A to show detail of resister which should be
changed.)
st signal block (Connector D1 to D4) is the Master
st Master port (D1). (No input required for the
© Mitsubishi Electric Corporation
60