"Remove the upper case (with keyboard)" on page 48
"Remove the LCD panel" on page 51
Step 1.
Open the latch and remove six screws. Then, remove the hinges, sensor board cable, and the EDP
cable from the LCD cover.
Figure 43. Open the latch and remove six screws, the hinges, sensor board cable, and the EDP cable from the
LCD cover
Screw specifications
M2.0 × L2.5
Step 2.
Use fingers to pull out the EDP cable and the left hinge rubber from the hinge.
Figure 44. Use fingers to pull out the EDP cable and the left hinge rubber from the hinge
Step 3.
Use fingers to pull out the sensor board cable and the right hinge rubber.
Number of screws
6
.
Chapter 4
Removing a FRU or CRU
53