Philips PL22.06 Service Manual page 15

Step/
Fig.
Loc. Part
No.
No.
LCD Panel
[13] D6
Assembly
[14] Front Bezel D6
  
(1) (2) (3)
Removal Note
7(S-14), 22(L-1),
3
Radiation Plate
Double Side Tape,
Rubber Spacer,
4
Diffusing Plate
Cushion
 
(4) (5)
Note:
(1) Order of steps in procedure. When reassembling,
follow the steps in reverse order. These numbers
are also used as the Identification (location) No. of
parts in figures.
(2) Parts to be removed or installed.
(3) Fig. No. showing procedure of part location
(4) Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P = Spring, L = Locking Tab, S = Screw,
H = Hex Screw, CN = Connector
e.g. 2(S-2) = two Screws of (S-2),
2(L-2) = two Locking Tabs of (L-2)
(5) Refer to the following "Reference Notes in the
Table."
Important precautions concerning the
LCD Panel Assembly:
1. When you disassemble/re-assemble the IR
Sensor CBA Unit.
• Be careful not to scratch the display panel when
assembling.
• Make sure the Sensor Shield, Sensor Lens, Stand
Rubber Foot, and IR Sensor CBA Unit are securely
in place when re-assembling.
2. When you remove the Cell Assembly.
• Refer to page 4-7.
3. When you disassemble/re-assemble the LCD
Panel Assembly.
• Do not pull the FFC Cable and Board Cable
forcefully when you re-assemble.
• Be careful not to scratch the display panel when
assembling.
• Make sure the T-CON Module and T-CON Holder
are securely in place when re-assembling.
4. When you disassemble/re-assemble the Front
Bezel.
• Be careful not to break the hook. If you pull with too
much force, the hooks may be damaged.
• Make sure to replace the Double Side Tape, Rubber
Spacer, and Diffusing Plate Cushion to a new one
when replacing the Front Bezel.
4-3 PL22.06-A_DC