Maintenance - Husqvarna BB 700 Operator's Manual

2. Select "Display".
3. Select "DGT".
4. Select "Error history". The last 10 errors are shown.
5. Select 1 of the errors for more information such as
operation mode, motor current and DC bus voltage.
To change the language for the display texts
1. Select "Interface" in the main menu.
2. Select "language" and select the language for the
display texts.
To operate the product
CAUTION:
time while you operate the product. If you
do not move the product, the surface can
become rough.
CAUTION:
burnisher head. Do not lift up on the handle
to add pressure during operation. This can
cause damage to the product and to the
floor.
1. Start to operate on 1 side of the surface, turn and
operate in the opposite direction. Make an overlap of
the part that is polished.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
General product maintenance
Do a check of all safety devices.
Make sure that nuts and screws are tight.
Do a check of the brush sealing for damages and wear.
Clean the electrical enclosure.
Do a check of the electrical components, the cables and
the connections for wear and damages.
Do a check of the hose connections. Do a check of all
hoses on the product for damages or leakage.
30
Move the product all the
Do not add weight to the

Maintenance

Before you do
2. Operate the product in parallel tracks and make sure
that the dust hose and the electric cable do not
become twisted.
3. Adjust the speed to the surface. Operate with lower
speed on a rough surface.
To stop the product
1. Push the stop button (A).
2. Make sure that all moving parts are stopped.
3. Remove the key of the operator presence control
from the product.
4. Disconnect the power plug.
5. Stop the dust extractor.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Daily Weekly
X
*
*
*
*
*
A
Each 3 Yearly
months
1823 - 003 - 13.04.2022