Table of Contents
Advertisement
How to Clean
Pipeline Cleaning
1. Install coffee basket, coffee jug, bean container and other
accessories (Please do not put ground coffee or beans in).
2. Pour water into the water tank until it reaches the position
of scale 4.
3. Pour 20 g citric acid into the water tank and stir it with a
sponge cleaning brush (Self-provided).
4. Cover with the water tank lid and wait for 30 minutes.
5. After plugging in the power plug, press the
select the cleaning mode for the internal pipeline
cleaning. When the
on LCD screen is on, press the
button to start cleaning.
6. After "Beep" for 8 times, the internal pipeline cleaning has finished.
7. After use, it is recommended to repeat steps 2-6 with clear water to remove the odor
of citric acid.
Powder Port Cleaning
1. Press the
button to select the Powder Port Cleaning Mode. When the
screen is on, press the
button.
2. After the "beep" sounds, the powder port will
open automatically. There will be ground coffee
falling, please pay attention.
3. Open the coffee basket rack.
4. Clean the powder port properly with a cleaning brush. Water droplets around the
powder port together with the ground coffee should be cleaned.
5. Close the coffee basket rack and press the
EN16
button to
on LCD
button to close the powder port.
Troubleshooting
Please check the following points before arranging for service.
Problem
Brewing speed is
Is there incrustant attached inside the machine?
●
slow or coffee is not
→Clean the pipeline with 20 g citric acid. (Page EN16)
coming out.
Button operation
Is the power plug loose?
●
is invalid.
→Be sure to plug in the power plug.
I
s the tank container filled with water?
●
→ Please fill the water tank container with the water
volume according to the number of coffee cups.
Is the coffee basket put in?
●
Coffee cannot be
→Please put the coffee basket in.
filtered.
I
s the filter put in?
●
→Please put the filter in.
Is the coffee jug installed correctly?
●
→ Please install the coffee jug in the correct position.
Too much ground coffee has been put in.
Ground coffee is spilled
●
→ Ground ground coffee should not be put in more than
from the filter.
7 level spoons.
Excessive water has been injected into the water tank.
Coffee is spilled
●
→Water filled in the tank should not exceed scale 6.
from the coffee jug.
The filter is damaged.
There are coffee grounds
●
in the coffee jug.
→Replace the filter.
Bean container is not installed correctly.
●
Display shows "U11".
→Please reinstall the bean container.
The motor is locked.
●
→ Please pull out the power plug and clean the bean
Display shows "U12".
grinding cavity.
→ If the above actions cannot help troubleshooting,
please contact Panasonic's direct service centre.
Water tank is not filled with water.
●
Display shows "U13".
→ Please pour proper water volume in the tank.
There may be ground coffee in the powder port.
●
→ Please pull out the power plug and clean the powder
port. (Page EN16)
Display shows "H04".
→ If the above actions cannot help troubleshooting,
please contact Panasonic's direct service centre.
Cause and Action
EN17
Hide quick links:
Advertisement
Table of Contents
