Trimming Beard - Panasonic ER-GB62 Operating Instructions Manual

Trimming beard

• Do not use with shaving foam applied or when the
beard is wet.
A wet beard may stick to the skin or bunch up, making
it difficult to trim.
Adjusting the beard length
• Make sure that the trimmer is turned off.
1
Attach the comb
attachment for beard to the
main body. (See page 9.)
2
Set the trimming height.
3
Holding the trimmer with
the power switch facing
upward, trim by bringing
the blade in contact with
the skin and moving the
trimmer against the flow of
the beard.
• Hair trimmings may collect
inside the attachment when
a large volume of beard is
cut, so discard hair trimmings
after each use.
10
Trimming without the comb attachment/
trimming the downy hair
1
Remove the comb attachment.
2
Holding the trimmer with the
power switch facing outwards,
trim by bringing the blade in
contact with the skin.
• The trimmer cannot trim hair
to lengths less than 0.5 mm.
Beard shaping
Use the trimmer without any comb attachments to
properly shape your beard.
►Above and below lips
Holding the trimmer with the power switch at the
bottom, cut across a line with the blade at a 90°
angle to the skin.