Troubleshooting Guide; Service Information - Black & Decker BDCJS20 Instruction Manual

ENGLISH

TROUBLESHOOTING GUIDE

BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
PROBLEM
Unit will not start.
Battery pack will not charge.
Unit shuts off abruptly.
Dust is not being collected.

SERVICE INFORMATION

BLACK+DECKER offers a full network of company-owned and authorized service locations. All BLACK+DECKER Service
Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. For more
information about our authorized service centers and if you need technical advice, repair, or genuine factory replacement
parts, contact the BLACK+DECKER location nearest you, or visit us at www.blackanddecker-la.com
34
POSSIBLE CAUSE
Battery pack not installed properly
Battery pack not charged.
Internal componets too hot.
Brushes worn out.
Battery pack not inserted into charger.
Charger not plugged in.
Surrounding air temperature too hot or too cold.
Battery pack has reached its maximum thermal
limit.
Out of charge. (To maximize the life of the
battery pack it is designed to shut off abruptly
when the charge is depleted.)
Sandpaper holes do not align.
Dust bag is full.
POSSIBLE SOLUTION
Check battery pack installation
Check battery pack charging requirements.
Allow tool to cool down.
Have brushes replaced by an authorized
BLACK+DECKER service center.
Insert battery pack into charger until LED
illuminates.
Plug charger into a working outlet. Refer to
"Important charging notes" for more details.
Move charger and battery pack to a surrounding
air temperature of above 40 degrees F (4,5°C) or
below 105 degrees F (+40,5°C).
Allow battery pack to cool down.
Place on charger and allow to charge.
Use sandpaper with the appropriate hole
configuration.
Separate dust bag and gently shake or tap to
empty.