Table of Contents
Advertisement
Chapter
2
Preparation
2
Thank you
Your new TV has many features and incorporates the latest technology to enhance your viewing
experience. We recommend that you spend some time reading this instruction manual so that you fully
understand these features. You will also find some hints and tips to help you resolve any issues.
Read all the safety instructions carefully before use and keep this instruction manual for future reference.
Unpacking the TV
Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.
The following items are included:
TV
TV Stand (base)
GB
Instruction Manual
28" LED Smart HD TV
LT-28C680
Instruction Manual
JVC 28' LED Smart HD TV LT-28C680 Manual.indd 7
for purchasing your new JVC TV.
TV Stand (neck)
3
Installing the TV Stand
Fitting the Stand Neck and Base Together
1. Fit the neck onto the base.
Quick Start Guide
2. Using 2 of the supplied screws, screw the neck to the base.
Fitting the Stand to the TV
3. Ensure the TV is switched off and not connected to the mains power supply.
28" LED Smart HD TV
4. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly
overhangs the edge of the table, with the back side facing up. Please make sure a soft cushioned
material (such as a dry bath towel or thick piece of foam) is placed beneath the screen.
LT-28C680
5. Slide the stand under the lip, the neck will fit snugly over the screw holes.
Then screw the stand to the TV using the 4 screws supplied.
Thank you
for purchasing your new JVC TV.
Your new TV incorporates the latest technology to enhance your
viewing experience. We would suggest that you allow about 20 mins
for initial setup.
Please follow this guide for a successful first time installation.
The latest eco-friendly power-saving technology will switch off
the TV if device is left on and idle for 4 hours. Please refer to "Auto
Standby" under the "Time Settings" section of the instruction
manual for more detail.
Protective
Bag
• Keep the protective bag on your TV until you have attached the stand and positioned the TV.
• The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object,
1
Unpacking
or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because
the screen could crack.
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.
4
TV
Remote Control/
Instruction Manual
Connecting the Aerial and Turning on the TV
TV Stand
AAA Batteries x2
Quick Start Guide
Screws x 6
1. Connect one end of the RF coaxial cable to the aerial socket on the wall
and the other end of the cable to the ANT socket on the back of your TV.
2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the
Please inspect your TV for damage after unpacking. If you do notice any damage please consult your dealer.
TV on. The LED indicator will flash for a few seconds then the TV will
switch on.
2
Operating Your Remote Control
1. Slide open the battery compartment on the back of the remote control.
2. Insert two AAA size batteries. Make sure to match the (+) and ( - )
ends of the batteries with the (+) and ( - ) ends indicated in the battery
compartment.
3. Slide the battery compartment cover back into place. Make sure it clicks
• Do not connect the TV to the mains supply until you have completed all the connections.
into place.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove the mains plug from the mains socket.
JVC 28' LED Smart HD TV LT-28C680 Quick Start Guide.indd 1
Quick Start Guide
Stand screws x6
LAN
SPDIF
VGA
Optic.OUT
SCART
Slide under
the lip
Cushioned
Table
material
TV stand (supplied)
Optional
If you want to connect to the internet via a wired connection
button on the remote control to turn the
then connect your ethernet cable to the LAN socket.
LAN
VGA
SPDIF
LAN
SPDIF
VGA
Coax.OUT
Coax.OUT
RF coaxial cable
SCART
(not included)
SCART
22/12/2017 14:17
2
3
.,/@
ABC
DEF
4
5
6
GHI
JKL
MNO
7
8
9
PQRS
TUV
WXYZ
0
TV
V
P
OK
EPG
TXT
LANG.
SUBT.
Remote Control /
AAA Batteries x 2
7
04/01/2018 09:16
Advertisement
Table of Contents
