Wirelesshd Settings Menu - Epson EH-LS9600e User Manual

Useful Functions
d
If projection does not start, press the
source.
Make sure you point the remote control at the projector when using the
control.
Projection starts.
e
When connecting two or more AV devices to the WirelessHD Transmitter, press the
button to switch images.
c
•
When receiving WirelessHD images, make sure WirelessHD is set to On from the Configuration menu.
Settings - WirelessHD - WirelessHD
s
•
Make sure you turn off the WirelessHD Transmitter if it is not going to be used for an extended period.

WirelessHD Settings Menu

a
Press the
Settings - WirelessHD from the
Configuration menu, and then press
the button to confirm the
selection.
The WirelessHD settings screen is
displayed.
Available functions on the WirelessHD settings menu
Function
Device Connections
WirelessHD
Reception
WiHD Mode
p.76
s
button, select
Displays a list of available WirelessHD devices that can be connected. The device names
and MAC addresses (device numbers) are displayed in the list. The MAC address is
displayed on the label on the base.
Enables or disables the WirelessHD function.
Displays the reception for the image being projected.
Use Full for most situations. Full mode uses the maximum video bandwidth at all times.
Dynamic mode extends wireless ranges while optimally adjusting video bandwidth.
Set to Dynamic if the image is interrupted due to weak signals and other causes.
button on the remote control to change the
p.91
b
Make settings for each of the
displayed functions.
Explanation
73
button on the remote