Table of Contents
Advertisement
oHome Connect
T his appliance is Wi-Fi-capable and can be controlled
H o m e C o n n e c t
using a mobile device.
If the appliance is not connected to your home network,
it will function as an extractor hood with no network
connection and can still be operated via the display.
The availability of the Home Connect function depends
on the availability of Home Connect services in your
country. Home Connect services are not available in
every country.You can find more information on this at
www.home-connect.com.
Notes
Ensure that you follow the safety instructions in this
■
instruction manual and that you comply with these
even when you are away from home and are
operating the appliance via the Home Connect app.
You must also follow the instructions in the
Home Connect app.
If the appliance is being operated by means of the
■
controls on the appliance itself, this mode of
operation always has priority. During this time, it is
not possible to operate the appliance using the
Home Connect app.
Setting up
To implement settings via Home Connect, you must
have installed and set up the Home Connect app on
your mobile device.
Refer to the Home Connect documents supplied for
more information.
Follow the steps specified by the app to implement the
settings.
The app must be open in order to perform the set-up
process.
In the networked standby mode, your appliance
Note:
requires a maximum of 2 W.
Automatic registration in the home network
Notes
You require a router that has WPS functionality.
■
You require access to your router. If you do not have
■
this, follow the steps for "Manually logging into your
home network".
The extractor hood cannot be switched on during the
■
connection process. You can cancel the process at
any time by pressing the
To connect the extractor hood to your home
■
network, the hood and the light must be switched off.
Press and hold the
D
1.
Press "1" to start automatic login to your home
2.
network.
The LED for fan setting 1 and the
Press the WPS button on the router within the next
3.
2 minutes.
If the extractor hood has successfully connected, it will
automatically connect to the Home Connect app. The
LED for fan setting 3 and the
symbol.
#
symbol until it starts to flash.
symbol will flash.
D
D
symbol will flash.
If the extractor hood has been unable to
Note:
connect, it will automatically allow you to manually
connect to your home network. The LED for fan
setting 2 and the
D
appliance into your home network manually or press
"1" to try logging in automatically again.
On your mobile device, follow the instructions for
4.
automatic network login.
The login process is complete when the
stops flashing on the control panel and remains
continuously lit.
Manual registration in the home network
Notes
The extractor hood cannot be switched on during the
■
connection process. You can cancel the process at
any time by pressing the
To connect the extractor hood to your home
■
network, the hood and the light must be switched off.
Press and hold the
D
1.
Press "2" to manually log into your home network.
2.
The LED for fan setting 2 and the
flash.
Use the "Home Connect" SSID and the "Home
3.
Connect" key to log the mobile device into the
extractor hood network.
If the extractor hood has successfully connected, it
will automatically connect to the Home Connect app.
The LED for fan setting 3 and the
flash.
On your mobile device, follow the instructions for
4.
manually logging into your network.
The login process is complete when the
stops flashing on the control panel and remains
continuously lit.
Home Connect en
symbol will flash. Log the
symbol
D
symbol.
#
symbol until it starts to flash.
symbol will
D
D
symbol will
symbol
D
11
Advertisement
Table of Contents
