Table of Contents
Advertisement
Sensor control
In automatic mode, the PerfectAir sensor in the
extractor hood detects the intensity of the cooking and
roasting odours. Depending on the setting of the
PerfectAir sensor, the fan automatically switches itself to
another fan setting.
Possible sensor settings:
Default sensitivity setting:
Lowest sensitivity setting:
Highest sensitivity setting:
If the sensor controller responds too strongly or not
enough, it can be changed accordingly:
Touch and hold the
1.
switched off. The setting will be displayed.
The sensor controller setting can be changed by
2.
touching symbols 1, 2, 3,
Take your finger off the
3.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols will flash once
the appliance has been switched off:
Metal grease filter:
■
Activated charcoal filter:
■
Metal grease filter and activated charcoal filter:
■
1 and 2
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 13
The saturation indicators can be reset while they are
flashing. To do this, touch the
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Touch and hold the
■
symbol.Take your finger off the
will switch the electronic controller over to air
recirculation mode (filters that cannot be
regenerated).
Touch and hold the
■
symbol.Take your finger off the
will switch the electronic controller over to air
recirculation mode (filters that can be regenerated).
Repeatedly touching and holding the
■
and touching the "1" symbol switches the electronic
controller back over to air extraction mode.
(fan setting 3)
„
‚
(fan setting 1)
(fan setting
†
D
symbol when the fan is
>
or
C
D
symbol.
>
and 1
#
and 2
#
symbol.
#
symbol. Touch the "2"
D
symbol. This
D
symbol. Touch the "3"
D
symbol. This
D
D
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
Setting the brightness
Press and hold the
brightness is reached.
Audible signal
)
Switching on
Touch and hold the
time for approximately 3 seconds when the fan is
switched off. An audible signal will sound as an
acknowledgement.
.
Switching off
Touch and hold the
time for approximately 3 seconds when the fan is
switched off. An audible signal will sound as an
acknowledgement.
,
#
symbol
Operating the appliance en
symbol.
B
B
symbol until the required
and
symbols at the same
#
y
and
symbols at the same
#
y
7
Advertisement
Table of Contents
