Table of Contents
Advertisement
WARNING
© Copyright 2014 ABB. All rights reserved.
Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
Removal and installation
Remove the turbocharger
Ribs (1) not in the middle at the top:
Completely remove the bearing casing insulation (2) and place a sling
around the bearing casing.
Loosen the fixing screws at the foot.
Lift the turbocharger off the engine and set it down to one side.
Beware of tilting
If support for the turbocharger is not provided or is inadequate, the
turbocharger could tip over during installation or removal and cause a
serious or even fatal injury.
Support the turbocharger at a suitable point.
If possible secure it using lifting gear.
Wear safety helmet.
Cover the oil connection.
7
7.2
Page 75
Advertisement
Table of Contents
