Toshiba GN-1050 Operator's Manual page 24

9.
NOTES: •
•
•
SUPPLEMENT: The encryption intensity between each encryption is:
AES(CCMP) > TKIP > Dynamic WEP
10.
GN-1050 Operator's Manual — Setting Up the Infrastructure Mode
Specify the following items and press the [NEXT] button.
ENCRYPTION BETWEEN AP AND STA.
Select the encryption type that is used for the communication between Access
Point and this equipment.
[TKIP] — Select this to use TKIP encryption. The TKIP provides a different key
for per packet with a message integrity check. This key will be changed for
every fixed interval.
[AES(CCMP)] — Select this to use AES encryption. The AES is the next-
generation cryptography algorithm that the U.S. government improves to replace
the DES and 3DES.
[Dynamic WEP] — Select this to use Dynamic WEP encryption. The Dynamic
WEP provides the encryption using WEP technology and it allows the WEP key
to change dynamically for every fixed interval. The Dynamic WEP does not
support the PEER KEY for IEEE802.1x.
When WPA or WPA2 is selected for the security mode, only [TKIP] or [AES(CCMP)]
can be selected.
When 802.1x is selected for the security mode and GN-1040 is used, either [TKIP],
[AES(CCMP)], or [Dynamic WEP] can be selected.
When 802.1x is selected for the security mode and GN-1050 is used, only [Dynamic
WEP] can be selected.
Specify the following items and press the [NEXT] button.
TRANSMIT POWER
Select the low transmit power if you want to limit the area that the wireless
communication is enabled. If you do not have to limit the area, select [100%].
1. Setting Up Wireless Network
23