Hitachi FT01 User Manual page 13

Installing the Finger Touch Unit
Secure the Finger Touch Unit (A) in place using one of the three methods below.
(1) Securing using double-sided tape
Peel off the backing paper (red side) of
strips to the Finger Touch Unit as shown
may be deteriorated unless four strips of
double-sided tape are used.
Peel off the backing paper (black side)
and press to adhere to the installation
location.
Double-sided tape (C)
Black side
" かべ面
Locations where installation is possible
NOTE
When removing the Finger
Touch Unit for dismantlement or other
removed by pulling part (c).
○
FT-01
Double-sided tape (C)
Red side
Pressure bonding
CAUTION
Locations where installation is not
possible
surfaces
Part (c)
13
Pull out so that
3M is visible.
×
Part (c)