Connecting The Inlet Hose - Bosch DV52J8060E Series User Manual

Installation

Connecting the inlet hose

26 English
DV8000J-03170M-01_EN-US_150122.indd 26
Method1
The dryer must be connected to the cold
water faucet using the new inlet hoses. Do
not use old hoses. (long hose : Canada model
only supplied)
1. If space permits, attach the brass female
end of the "Y" connector to the cold
water faucet.
2. Turn the cold water faucet off.
3. Attach the straight end of the long hose
to the "Y' connector.
4. Using pliers, tighten the coupling with
an additional two-thirds turn.
NOTE
Do not overtighten, as it may damage the
coupling.
5. Attach the angled end of the long
hoses to the fill valve at the bottom of
the dryer's rear frame. Screw on the
coupling by hand until it is seated on the
fill valve connector.
6. Using pliers, tighten the coupling with
an additional two-thirds turn.
NOTE
Do not overtighten, as it may damage the
coupling.
7. Turn the cold water faucet on.
8. Check for leaks around the "Y" connector,
faucets, and hoses.
2015/1/23 16:29:58