Yamaha 01V Owner's Manual page 158

148
Chapter 12—Effects
DYNA.PHASER
Dynamically controlled phaser.
Parameter
SOURCE
SENSE
FB GAIN
OFFSET
DIR.
STAGE
DECAY
1. 6.0 ms–46.0 s (fs=44.1 kHz), 5.0 ms–42.3 s (fs=48kHz)
REV+CHORUS
Reverb and chorus effects in parallel.
Parameter
REV TIME
INI.DLY
HI.RATIO
DENSITY
FREQ.
NOTE
DEPTH
MOD.DLY
WAVE
REV/CHO
HPF
LPF
TEMPO
1.
2. For more information about the FREQ., NOTE, and TEMPO parameters, see "Setting
01V—Owner's Manual
Range
INPUT, MIDI
0–100
–99 to +99%
0–100
UP, DOWN
2, 4, 8, 10, 12, 14, 16 Number of phase shift stages
*1
Range
0.3–99.9 s
0.0–500.0 ms
0.1–1.0
0–100%
0.05–40.00 Hz
*1
0–100%
0.0–500.0 ms
Sine, Tri
0–100%
Thru, 21 Hz–8.0 kHz
50 Hz–16.0 kHz, Thru Low-pass filter cutoff frequency
*2
25–300 bps
Delay, Freq, Note & Tempo Parameters" on page 137.
Description
Control source: input signal or MIDI note on velocity
Sensitivity
Feedback gain (plus values for normal-phase
feedback, minus values for reverse-phase feedback)
Lowest phase-shifted frequency offset
Upward or downward frequency change
Decay speed
Description
Reverb time
Initial delay before reverb begins
High-frequency reverb time ratio
Reverb density
Modulation speed
Used in conjunction with TEMPO to determine FREQ.
Modulation depth
Modulation delay time
Modulation waveform
Reverb and chorus balance (0% = chorus, 100% =
reverb)
High-pass filter cutoff frequency
Used in conjunction with NOTE to determine FREQ.