300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA 90620 The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.
• Hold the power cord plug when disconnecting from an AC outlet. Never pull the cord. Damaging the power cord in this way is a potential fire and electrical shock hazard. • Do not place small metal objects on top of the power supply unit.
Thank you for choosing the PW1D, a power supply unit designed for the CS1D Yamaha control surface. To install the unit, please select a location with good ventilation. Do not block the front panel or rear panel or you may restrict fan air flow. Be sure to use the included special cable to connect the unit to the CS1D.
DC OUTPUT connector pin assignment Pin No. Function +60 V +60 V FRAME GND +60 V +60 V +60 V +60 V +60 V +60 V +60 V DC Output connector Dimensions • Specifications and appearance are subject to change without notice for improvement. •...
Page 6
YAMAHA CORPORATION Pro Audio & Digital Musical Instrument Division P.O. Box 3, Hamamatsu, 430-8651, Japan...