D-Link AirPlus Xtreme G DWL-G520 Manual page 14

Configuration Utility (continued)
Configuration
SSID: Service Set Identifier is a name that identifies a wireless network. Access points
and wireless devices attempting to connect to a specific WLAN (Wireless Local Area
Network) must use the same SSID.The default setting is default.
Wireless Mode:
Infrastructure
default setting.)
Ad-Hoc - Wireless mode used when connecting directly to a computer equipped
with a wireless adapter in a Peer-to-Peer environment.
The following choices are available when
SUPER G:
to communicate on the network.
11B: when this option is selected, only devices set to 802.11b will be able to
communicate on the network.
11G: when this option is selected, only devices set to 802.11g will be able to
communicate on the network.
Ad-Hoc Band: select either 802.11b or 802.11g as the band for Ad-Hoc communication.
Channel: The channel selection is automatically determined by the DWL-G520. In Ad-
Hoc mode, the channel must be manually set to the same channel for each wireless
adapter.
Tx Rate: Tx rates are automatically determined for an optimal speed up to 54Mbps.
(108Mbps in Super G mode).
Power Mode: Select from three modes:
Continuous Access Mode
Maximum Power Save -
Power Save -
Click Apply to save the changes.
Click on the pull-down menu; select from the following options:
- Connecting to the WLAN using an access point. (This is the
when this option is selected, only devices set to Super G will be able
- This default setting consumes the most power.
This setting consumes the least power.
This setting consumes a moderate amount of power.
Infrastructure is selected in
14
Wireless Mode: