Table of Contents
Advertisement
DIR-615 Wireless N300 Router
User Manual
WPS
On the Functions / Wi-Fi / WPS page, you can enable the function for configuration of the
WLAN.
The WPS function helps to configure the wireless network automatically. Devices connecting to the
wireless network via the WPS function must support the WPS function.
!
The WPS function allows adding devices only to the basic wireless network of the router.
Before using the function you need to configure one of the following authentication types:
!
Open with no encryption, WPA2-PSK or WPA-PSK/WPA2-PSK mixed with the AES
encryption method. When other security settings are specified, controls of the WPS page
are not available.
You can activate the WPS function via the web-based interface or the hardware WPS/RESET
button on the cover of the device.
To activate the WPS function via the hardware button, move the Enable Wi-Fi when WPS
function is activated with hardware button switch to the right. Then, with the device turned
on, push the WPS/RESET button and release it. The WLAN/WPS LED should start blinking
slowly. In addition, upon pushing the button, the wireless interface of the device is enabled if it was
disabled before.
If you want to disable activating the WPS function via the hardware button, move the Enable
Wi-Fi when WPS function is activated with hardware button switch to the left and make
sure that the WPS function is not activated via the web-based interface.
To activate the WPS function via the web-based interface, click the ENABLE WPS button.
Figure 98. The page for configuring the WPS function.
Page 115 of 176
Configuring via Web-based Interface
Advertisement
Table of Contents
