DIR-615 Wireless N300 Router
User Manual
Figure 120. The window for changing the settings of the router's port.
In the opened window, specify the needed parameters:
Parameter
Speed
Data transfer mode.
Select the Auto value to enable autonegotiation. When this value is
selected, the Autonegotiation Modes and Flow Control
sections are displayed.
Select the 10M-Half, 10M-Full, 100M-Half, or 100M-Full value
to manually configure speed and duplex mode for the selected port:
10M-Half: Data transfer in just one direction at a time (data
•
can be either sent or received) at the maximum possible rate
of up to 10Mbps.
10M-Full: Data transfer in two directions simultaneously
•
(data can be sent and received at the same time) at the
maximum possible rate of up to 10Mbps.
100M-Half: Data transfer in just one direction at a time (data
•
can be either sent or received) at the maximum possible rate
of up to 100Mbps.
100M-Full: Data transfer in two directions simultaneously
•
(data can be sent and received at the same time) at the
maximum possible rate of up to 100Mbps.
Page 143 of 176
Configuring via Web-based Interface
Description