Bosch L35MOVE2 Operating Instructions Manual page 8

the dust bag by pulling on the locking tab.
out the dust bag.
a new dust bag.
the dust bag fully into the holder.
note: the lid will only close if a dust bag has
inserted.
motor protection
knocking out the dirt and rinsing.
Open the dust bag compartment lid.
Release the motor protection filter from the catch by
pulling it sideways, and pull it out in the direction of
the arrow.
Clean the motor protection filter by tapping out the
dirt.
If it is very dirty, the motor protection filter should be
rinsed.
( The filter must then be left to dry for at least 24 hours.
After cleaning, refit the motor protection filter into
the appliance, lock it in place and close the dust bag
compartment lid.
should be replaced with every replacement
the dust bag compartment lid.
the holder by moving the locking lever
the direction of the arrow.
the micro
micro
( must then be left to dry for at least 24
the micro
into the appliance.
the holder into the appliance and lock it
place.
your vacuum cleaner is equipped with a
must be replaced once a year.
the dust bag compartment lid.
the
direction of the arrow and remove the
appliance.
the new
vacuuming dust particles, clean the motor
and, if necessary, replace the micro
or
should be cleaned regularly
can be rinsed out.
Insert the new
by moving the locking lever in
and lock it in place.
on model
switch off the vacuum cleaner and disconnect it
the mains before cleaning the vacuum cleaner. The
cleaner and plastic accessories can be cleaned
ordinary plastic cleaner.
required, the dust compartment can be vacuumed out
a second vacuum cleaner or simply with a dry
dusting brush.
to technical modi
from