Mitsubishi Electric AG-150A-A Installation Manual page 16

M-NET transmission cable
9 Attach the controller to the A type installation plate with the roundhead screws (supplied).
Wall
0 Replace the AG-150A surface cover.
2-3. Wall-mounting the centralized controller with the mounting attachment B type
(PAC-YG81TB; sold separately)
1 Ensure there is enough space to install the controller as
shown in the figure at right.
NOTES
* When installing two or more controllers side-by-side and horizontally ensure that there is at least 130 mm (5-
between the units.
* When installing two or more controllers vertically, ensure that there is at least 150 mm (5-
be hard to remove the cover.
* The amount of space required on the left of the controller is the amount necessary to connect/disconnect the USB drive. (If the
specified amount of space is not available, use a USB extension cable.)
* The amount of space required under the controller is the amount necessary for the mounting/dismounting of the controller
cover.
M-NET transmission cable
DC power cable
* When a PAC-YG50ECA Expansion controller is used,
the M-NET terminals will not be used.
* When using bridge wiring of the shield,
A
B
Back of controller
shield
use the S-terminal as shown below.
S
M4 rounded screw
(supplied)
100 (3- 15 / )
16
- 15 -
DC power cable Function earthing
(ground) cable
Unit: mm (in)
30 (1- / )
3
16
300 (11- / )
13
16
1 /
15 / in) between units; otherwise, it will
16
Mounting attachment
B type
(PAC-YG81TB; sold
separately)
in) or more
8