Mitsubishi Electric AG-150A-A Installation Manual page 19

0 Connect the wiring from the power supply unit to the
centralized controller.
M-NET transmission cable
(supplied with PAC-YG85KTB)
a Install the controller inside the mounting attachment A type
(PAC-YG85KTB) with the four M4 rounded screws (supplied
with PAC-YG85KTB).
b Replace the AG-150A surface cover.
c Attach the power supply unit cover with the two screws.
(Supplied with PAC-YG85KTB)
DC power cable
(supplied with
PAC-YG85KTB)
- 18 -
M-NET
transmission cable
(supplied with
PAC-YG85KTB)
NOTE
* When using an LAN and external signal
I/O, refer to section
11 External input/output usage .
DC power cable
(supplied with PAC-
YG85KTB)
M4 roundhead
screw (supplied
with PAC-
YG85KTB).
Screws (supplied with
PAC-YG85KTB)