Pnp/Pci Configuration - Acer Aspire T100 Service Manual

PnP/PCI Configuration

The following table describes the parameters found in this menu. Settings in boldface are the default and
suggested settings.
Parameter
Reset Configuration Data
Resources Controlled By
IRQ Resources
PCI/VGA Palette Snoop
NOTE: It is strongly recommended that only experienced users should make any changes to the default
settings.
36
Description
Selecting "Enabled" to reset Extended
System Configuration Data (ESCD) only if
you installed a new add-on and the system
reconfiguration has caused such a serious
conflict that the operating system can not
boot. Otherwise, you should leave it
unchanged.
This BIOS can automatically configure all
of the boot and Plug and Play compatible
devices. You can also set it as Manual
and go into each of the sub menu to
choose specific resources.
The items are adjustable only when
"Resources Controlled By" is set to Manual.
By pressing "Enter" to access the sub
menu.
Disabled - Data read or written by the CPU
is only directed to the PCI VGA device's
palette registers.
Enabled - Data read or written by the CPU
is directed to both the PCI VGA device's
palette registers and the ISA VGA device's
palette registers, permitting the palette
registers of both VGA devices to be
identical.
Options
Disabled
Enabled
Auto (ESCD)
Manual
PCI Device
Reserved
Disabled
Enabled
*If any ISA bus adapter in the
system requires VGA Palette
snooping, the setting must be
set to "Enabled".
Chapter 2