Advertisement

Quick Links

Advertisement

Table of Contents
loading

Summary of Contents for Siemens LC98BC540

  • Page 2: Table Of Contents

    INSTRUCTION MANUAL Produktinfo Environmental protection Additional information on products, accessories, replacement parts and services can be found at www.siemens-home.com This appliance is labelled in accordance with the and in the online shop www.siemens-eshop.com European Directive 2012/19/EU concerning used Please find the contact data of all countries in the enclosed electrical and electronic appliances (WEEE –...
  • Page 3 Installation Risk of electric shock! from damaged connection cable. Do not kink or pinch Danger to life! Risk of poisoning! connection cable during installation. from combustion gases sucked back in. Never operate the appliance in the exhaust air mode at the same time as a room Risk of fire, risk of injury! air-dependent heat-producing appliance unless an adequate from damaged connection cable.
  • Page 4: Operating Modes

    Cleaning and care Maintenance and repair Risk of burns, risk of electric shock! Risk of fire, risk of injury! from appliance. Always leave appliance to cool down before from improper repairs. Switch off the fuse or pull out the mains cleaning or servicing.
  • Page 5: Installing And Removing The Filter

    Switching on the fan: variant 1 Control panel variant 2 Press the On/Off button. The fan setting can be increased with the button or reduced with the button. Intensive setting You can use the intensive setting if there is a large build-up of odours and fumes/vapours.
  • Page 6: Cleaning And Care

    Cleaning and care Cleaning the metal mesh grease filters Risk of burns, risk of electric shock! The inserted metal mesh grease filters absorb the grease from appliance. Always leave appliance to cool down before particles from the kitchen fumes. Clean the metal mesh grease cleaning or servicing.
  • Page 7: Installation Instructions

    INSTALLATION INSTRUCTIONS Installation instructions This appliance is installed on the wall. ■ Follow the enclosed installation instructions for additional ■ special accessories (e.g. for circulating-air mode). The surfaces of the appliance are sensitive. Avoid damaging ■ them during installation. Safety information Danger to life! Risk of poisoning! from combustion gases sucked back in.
  • Page 8: Installation

    Installation Pipe dimensions Preparing for installation Note: The device manufacturer does not assume any warranty Mark a vertical centre line on the wall from the ceiling to the for complaints attributable to the pipe section. lower edge of the extractor hood. Mark the positions for the screws and the contour of the The device achieves its optimum performance by means of a ■...
  • Page 9 Screw in threaded pin, leaving it protruding out of the wall by Securing the appliance 5 - 9 mm.. ª Press the safety caps with the arrow upwards onto the brackets until they engage. ® Screw on the knurled nut and washer firmly. ¯...
  • Page 10: Attaching The Flue Duct

    Connecting the pipes Separate the flue ducts. To do this, remove the adhesive tape. Note: If using an aluminium pipe, smooth the connection area Remove the protective foil from both flue ducts. beforehand. Push one flue duct into the other. Exhaust-air pipe Ø...
  • Page 12 Siemens-Electrogeräte GmbH Carl-Wery-Straße 34 81739 München Germany *9000548221* 9000548221 930903...

Table of Contents