Compliance With Standards; Using The Body Analysis Scale; Preparing For Use; Inserting/Removing The Batteries - Philips DL8780/37 Manual

Compliance with standards

Using the body analysis scale

Preparing for use

Inserting/removing the batteries

-
The device meets the relevant standards for this type of Class II electrical
medical equipment for home use.
-
This Philips device complies with all applicable standards and
regulations regarding exposure to electromagnetic fields and complies
with IEC 60601-1-2.
-
This Philips device complies with applicable standards and regulations of
the FCC Rules.
This Philips body analysis scale automatically switches on as soon as you
step on the measurement platform. The device applies BIA (bioelectrical
impedance analysis) technology. Weak current flows through the human
body to measure the bioelectrical impedance and estimate body fat
percentage. The electrical current is small and may not be felt.
This BIA technology is non-invasive. The electrical current mentioned above
is less than 1mA.
Insert new batteries (4x 1.5V AAA alkaline) before the first use.
Replace weak batteries before they discharge completely.
Note: Data will be lost when the battery is completely empty.
If you do not intend to use the device for a long period of time,
it is advised to remove the batteries before storing.
Caution: Replace all four batteries at the same time. Do not mix the old
batteries with the new ones.
This device has a battery low indication. When the battery level is below
operating value, this will be indicated by the low battery icon after which the
device shall switch off within 4 sec.
1 Open the battery compartment at the back of the device.
2 Insert the batteries (4x 1.5V AAA alkaline) into the battery compartment
according to the polarity indications marked inside the compartment.
English
11