NEC LS-D2462CL Owner's Manual page 10

How to use the Operation Mode Selection button
Cooling Operation
Press the Start/Stop button. The unit will respond with a beep.
1
Open the door on the remote control. To select Cooling
2
operation, press the Operation Mode Selection button.
Each time the button is pressed, the operation mode is shifted
in the direction of the arrow.
Cooling
Close the door on the remote control.
3
Set the temperature lower than the room temperature. The
temperature can be set within a range of 18°C~30°C in 1°C
increments.
Set the fan speed again with the door of the remote control
4
still closed. You can select the fan speed in four steps-low,
medium, high, or CHAOS. Each time the button is pressed,
the fan speed mode is shifted.
10
Soft Dry Auto
(Heat pump model only)
To raise the temperature
To lower the temperature
Heating