Get Started; Charge The Battery - Philips TAT3215 User Manual

3 Get started

Charge the battery

Note
•
place the headsets in the charging case and
charge the battery for 3 hours for optimum
battery capacity and lifetime.
•
Use only the original USB charging cable to
avoid any damage.
•
Finish your call before charging the headset,
as connecting the headset for charging will
Charging case
Connect one end of the USB cable into
the charging case, and another end into
the power source.
The charging case starts charging.
• Charging process is veri ed by the
blue LED light on the front panel.
• When the charging case is fully
charged, the blue light goes on.
Tip
•
The charging case serves as a portable backup
battery for charging the headset. When the
charging case is fully charged, it supports 3 full
recharge cycle for the headset.
Headset
Place the headset in the charging case.
The headset start charging.
• Charging process is veri ed by
white LED lights on the earpieces.
• When the headset is fully charged,
Tip
•
Normally, a full charge takes 2 hours (for the
headset or charging case).
Pair the headset with
your Bluetooth device at
the rst time
Make sure that the headset is fully
charged.
Take both headsets from the
charging case, the headset will
power on automatically, entering
pairing model and Right & Left
headset connected.
here will be a voice "Power on" and a
voice "Pairing". Then, there will be a
voice" Right channel" on right headset
and "Left Channel" on left headset
after paring each other.
EN