SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage • compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. •...
• Do not put electrical appliances (e.g. ice cream • Before maintenance, deactivate the appliance makers) in the appliance unless they are stated and disconnect the mains plug from the mains applicable by the manufacturer. socket. • Be careful not to cause damage to the •...
A medium setting is generally the most CAUTION! If the ambient temperature suitable. is high or the appliance is fully loaded, However, the exact setting should be and the appliance is set to the lowest chosen keeping in mind that the temperatures, it may run continuously temperature inside the appliance causing frost to form on the rear wall.
1. Fill these trays with water Do not use metallic instruments to 2. Put the ice trays in the freezer compartment. remove the trays from the freezer. HINTS AND TIPS NORMAL OPERATING SOUNDS polythene bag to exclude as much air as possible.
CARE AND CLEANING This operation will improve the performance of WARNING! Refer to Safety chapters. the appliance and save electricity consumption. DEFROSTING OF THE REFRIGERATOR GENERAL WARNINGS Frost is automatically eliminated from the evaporator of the refrigerator compartment every CAUTION! Unplug the appliance time the motor compressor stops, during normal before carrying out any maintenance use.
1. Disconnect the appliance from electricity WARNING! Do not touch frozen supply. goods with wet hands. Hands can 2. Remove all food. freeze to the goods. 3. Defrost (if necessary) and clean the appliance 3. Leave the door open. and all accessories. In order to speed up the defrosting process, 4.
Page 9
Problem Possible cause Solution Food products placed in the Allow food products to cool to appliance were too warm. room temperature before stor- ing. The door is not closed correct- Refer to "Closing the door". There is too much frost and The door is not closed correct- Refer to "Closing the door".
Problem Possible cause Solution There is too much condensed Door was opened too fre- Open the door only when nec- water on the rear wall of the re- quently. essary. frigerator. Door was not closed com- Make sure the door is closed pletely.
Page 11
LOCATION Refer to the assembly instructions for the installation. To ensure best performance, install the appliance well away from sources of heat such as radiators, boilers, direct sunlight etc. Make sure that air can circulate freely around the back of the cabinet. POSITIONING Install the appliance in a dry, well ventilated indoors where the ambient temperature corresponds to the...
TECHNICAL DATA TECHNICAL DATA Height 1441 Width Depth Rising time Hours Voltage Volts 230 - 240 Frequency The technical information is situated in the rating plate, on the external or internal side of the appliance and in the energy label. ENVIRONMENTAL CONCERNS with the symbol with the household waste.